Products
Ball Valve
Ball valves are commonly used in industrial applications to control the flow of fluids. The Ball valve BS EN ISO 17292 and ASME B 16.34 are two commonly used standards for ball valves.
Butterfly Valve
Butterfly valves are a family of quarter-turn rotational motion valves that are used in pipelines to shut-off flow. It is often said that butterfly valves can be used to regulate the flow.
Check Valve
The primary purpose of a check valve is to prevent backflow in the system. Check valves are cheap, effective, and easy solutions to a potential issue.
GATE VALVE
the most common valve for water supply systems. It represents a linear-motion isolation valve and has a function to stop or allow the flow. The gate faces can be parallel but are most commonly wedgeshaped
GLOBE VALVE
Globe valves are used primarily in situations where throttling of the commodity is required. By simply rotating the handwheel, the rate at which the commodity flows through the valve can be adjusted to any desired level.
Electric Actuator
An electric actuator is a mechanical device used to convert electricity into kinetic energy in either a single linear or rotary motion. It automates damper or valve in order to increase process efficiency and complexity.
Pneumatic Actuator
Pneumatic actuators are devices that convert the energy of compressed air or gas into a mechanical motion that regulates one or more final control elements.hat helps converting energy, often electrical, air, or hydraulic.
PLUG VALVE
Plug valves are an excellent option for many commercial and light industrial applications, including directional flow control, handling of gas or liquid fuels, regulating fluids with suspended solids, such as slurries, , low-temperature .
“PRV” PRESSURE REDUCING
A Pressure Reducing Valve is an Automatic Control Valve designed to reduce a higher unregulated inlet pressure to a constant, reduced downstream pressure regardless of variations in demand
RESILIENT SEATED GATE
A resilient seated gate valve has a plain valve bottom allowing free passage for sand and pebbles in the valve. If impurities pass as the valve closes, the rubber surface will close around the impurities while the valve is closed
KNIFE EDGE GATE Valve
Knife gate valves are designed mainly for on-off and isolation services in systems with high content of suspended solids. Knife gate valves are especially beneficial for handling slurry in addition to viscous,and abrasive media.
Y TYPE STRAINER Valve
Strainers are devices for mechanically removing unwanted solids from liquid, gas or steam lines by means of a perforated or wire mesh straining element. They are used in pipelines to protect pumps, meters.
UPVC VALVE
UPVC ball valves are mainly used to cut off or connect the medium in the pipeline, and can also be used for fluid regulation and control.its fluid resistance is quite small.
NEEDLE VALVE
Needle Valve offer more precise control over fluid flow than other valves. This is because the needle in a needle valve can create a very tight seal, which allows for a much smaller opening through which fluid can pass.
